Using a Remote Node

The current list of available remote nodes on the network can be found here

You can set the daemon to point to a remote node using the set_daemon command in your CLI wallet.

Once the wallet is open you will see an error message as per below:

Error: wallet failed to connect to daemon: http://localhost:17750. Daemon either is not started or wrong port was passed. Please make sure daemon is running or change the daemon address using the 'set_daemon' command.

Ignore this error and enter one of the following to connect to a remote node:

  • set_daemon trusted
  • set_daemon trusted
  • set_daemon trusted

Type refresh and it will connect to the remote node and sync your wallet. Once synced you can then use your wallet as normal.

Previous Onshore Conversion
Next Using a Local Node
en_GBEnglish (UK)